Kenwood DMF-9020 User Manual

DMF-9020/MD-2070 (En)
25
Recording-related keys
Set the recording pause mode.
¶ª
Recording can be started or paused simultaneously with the
sound and from the sound approximately 6 seconds before
the current sound.
Preparation
Automatically starting recording when the track starts (SOUND SYNCHRO REC)
Recording starts when a sound above a certain level is input.
This function is particularly convenient when combined
with the AUTO CUT function to record selected tracks.
Press while in the recording pause mode.
When the track starts, recording starts.
÷
OVER ( − dB)
R
L
SOUN
D
S
YNC.
∞
15
912 7
5
1
3
40 30
21
18
0
SEARCHPGM
MONITOR
ANALOG
32kHz
213
48kHz
44.1kHz
DIGITAL
÷The sound detection level can be adjusted with the REC MODE “AUTO
LEVEL” setting.
¢
÷When the ¶ key is pressed again, the normal recording pause mode is
set.
÷For some music sources, the beginning of the track may be cut off.
Automatically pausing recording when the track ends (REC AUTO PAUSE)
Recording is automatically paused when the sound input is
below a certain level for over 3 seconds or when the track
number changes during digital recording of a CD.
This function comes in handy when you only want to record
one track from the CD.
Press while in the recording or recording pause
mode.
÷The sound detection level can be adjusted with the REC MODE “AUTO
LEVEL” setting.
¢
÷Press the 7 key or the AUTO PAUSE key again to cancel the REC AUTO
PAUSE mode.
AUTO PAUSE
OVER ( − dB)
A . PAUSE
R
L
∞
15
912 7
5
1
3
40 30
21
18
0
SEARCHPGM
MONITOR
ANALOG
32kHz
213
48kHz
44.1kHz
DIGITAL
“A. PAUSE” lights up
Starting recording from the sound before the current sound (MEMORY REC)
Recording starts from the sound 6 seconds before the point
at which the key is pressed.
Use this for example when recording radio programs.
Press while in the recording pause mode.
Recording starts from the sound 6 seconds be-
fore the current sound.
SET
÷It is not possible to start recording from the sound 6 seconds before the
current sound if less than 6 seconds have passed in the recording pause
mode.
÷When the fade mode is ON, the fade mode is switched OFF before
recording starts.

Kenwood DMF-9020 Specifications

Digital Audio System

playing rotation	Approx. 400 rpm ~ 900 rpm (CLV)
frequency response (playback mode)	8 Hz ~ 20 kHz (± 1 dB)
signal to noise ratio (playback mode)	More than 112 dB

D/A and A/D Conversion

D/A conversion	1 Bit (24 bit type)
oversampling	8 fs (352.8 kHz)
A/D converter	4th order sigma-delta conversion+ D.R.I.V.E. conversion

Input and Output

analog input sensitivity / input impedance	500 mV / 22 kW
analog output level / output impedance	2.0 V / Less than 300 W
headphone output	50 mW/32 W load (Phones level MAX)

General Specifications

power consumption	20 W
dimensions	W: 440 mm, H: 125 mm, D: 373 mm
weight (net)	5.4 kg (11.9 lb)