Kenwood DMX957XR User Manual

Controlling Audio
87English
Controlling Audio
You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [MENU] button.
 Popup menu appears.
2
Touch [Audio].
See the following section for each
setting.
• Set up Speaker / X’over (P.88)
• Controlling EQ / SW Level (P.90)
• Set Position / DTA (P.94)
• Controlling Fader / Balance (P.90)
• Set Volume Offset (P.91)
• Performing Zone Control (P.92)
• Set Sound Effect (P.93)
• Use Audio Memory (P.95)
3-way speaker system setup
(DDX9907XR / DMX957XR /
DMX907S)
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [HOME] button.
 HOME screen appears.
2
Touch [ ].
 Source selection screen appears.
3
Touch [STANDBY].
4
Press the button 1 followed by the
button 2 for 1 second at the same time.
DDX9907XR
2 1
DMX957XR / DMX907S
1 2
 Speaker system select screen appears.
5
Select the crossover network mode.
 A confirmation screen appears.
6
Touch [Ye s].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched.

Kenwood DMX957XR Specifications

General

Brand	Kenwood
Model	DMX957XR
Category	Car Video System
Language	English