Kenwood GE-9X User Manual

DEAR AUDIO FAN
The purpose of this manual is to acquaint you with ihe operating fealures of your new GE-9X
You will notice that in every detail of planning, engineering, styling, operating convenience, and
adaptability, we have sought to anticipate your needs and desires.
We suggest that you read this manua! carefully. Knowing how to set up your GE-9X fo ihe best
advantage wilf enhance your listening pleasure right from the start. You will also become aware of
the ease with which you can adiust your GE-8X to meet your special requirements
CONTENTS
BEFORE OPERATION
SYSTEM CONNECTIONS..........
CONTROLS AND INDICATORS ..
OPERATING INSTRUCTIONG...... eo
EFECTIVE USE OF THE MODEL GE-SX
IN CASE OF DIFFICULTY
SPECIFICATIONS........0...:ss0seees
~COMmoahwW
FOR YOUR RECORDS
Record the serial number, found on the back of the
unit, in the spaces designated on the warranty card, and
in the space provided below. Refer to the model and
serial numbers whenever you call upon your Kenwood
dealer for inforrnation or service on this product.
Model GE-9X Serial number.
UNPACKING
Unpack the unit carefully and make sure that all ac-
cessories end cables are put aside so they will not be
lost.
Examine the unit for any possibility of shipping
damage. If your unit is damaged or fails to operate,
notify your dealer immediately. If your unit was shipped
to you directly, notify the shipping company without
delay. Only the consignee (the person or company
receiving the unit) can file a claim against the carrier for
shipping damage.
We recommend that you retain the original carton and
packing materials for use should you transport or ship
the unit in the future,
WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
2 GFX
|
! IMPORTANT!
i
i U.S.A. AND CANADA
! Units shipped to the U.S.A. and Canada are
designed for operation on 120 volts AC only.
These units are not equipped with an AC Voltage
Selector switch and the discussion of such a
switch that follows should be disregarded
1
H
ALL OTHER COUNTRIES
Unils shipped to countries other than the
U.S.A. and Canada are equipped with an AC
Voltage Selector switch on the rear panel.
Refer to the following paragraph for the proper
i setting of this switch.
ACG VOLTAGE SELECTION
This unit operates on 110-120 volts or
220-240 volts AC.The AC Voltage Selector Switch on
the rear panel is set to the vollage that prevails in the
area to which the unit is shipped. Before connecting
the power cord to your AC outlet, make sure that the
setting position of this switch matches your line
voltage. If not, it must be set to your voltage in accor-
dance with the following direction
Note:
Our warranty does rot
voltage due to impr
1 cover damage caused by ex
AC Voltage Sel
sive line
Switch.
110-120V~ 4» 220-240V~ 110-1 20V~ «m 220-240V~
_-: Switch lever
® ER esto 7) 6
This shows switch ~~
lever is locked in
! 220-240V~posttion.
This shows switch |
lever is locked in
140-1 20Vposition.
Move switch fever to match your
line voltage with a small screw
driver or other pointed toot.
AC VOLTAGE SELECTOR SWITCH

Kenwood GE-9X Specifications

Equalizer Characteristics

variable range	+12 dB
total harmonic distortion	0.006% at 20 Hz to 20 kHz
maximum output voltage	9 V at 1 kHz, 0.01% THD

Frequency Response

frequency response	10 Hz to 30 kHz, +0 dB, -1 dB
signal to noise ratio	+103 dB at 1 V
attenuator (ATT)	-6 dB

Impedance

input impedance	50 kohms
output impedance	600 ohms
insertion loss	0 dB (all controls defeated)

Power and Dimensions

power consumption	0.15 A (U.S.A.) / 17 W (Others)
dimensions (W x H x D)	440 mm x 109 mm x 315 mm
weight	4.4 kg