Kenwood KR-694 User Manual

_satety precautions _
a y Units are dasigued for operation as follows.
U.S.A. Mexico and Canada ...cscsssssscsrrrecssernrsssessvrssneesnneee 120 V only Other COUNETIOS 6... eccccesseseonerssesssserseesnrer wecsecseceee 110-120 / 220-240 V swite
PRUSUCANI sas ciitcvensecin tions tassssastinnsterreccpteceesedlecislais slsssbaintertoreesiaseen AO V ORIV
AC
voltage
selection
AC
voltage
selector
switch
This unit operates on 110 - 120 volts or 220 - 240 volts.
AC. The AC voltage selector switch on the rear panel is
set to the voltage that prevails in the area to which the
unitis shipped. Before connecting the power cord to your
AC outlet, make sure that the setting pasition of this
switch matches your line voltage. If not, it must be set to
your voltage in accordance with the following direction.
ae AC 110-120V~ AC 220-240V- F
—
Note:
Our warranty does not cover damage caused by excessive line volt- Mave switch lever to match your line voltage
age cue to improper setting of the AC Voltage selector switch. with a smal] screwdriver or other pointed tool.
ol 3 =n
Ca Pata NG NT NS ANT
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
AISK OF ELECTRIG SHOCK (OR BACK), NO USER-SERVICEABLE PARTSINSIDE, REFER SERVICING TO QUALIFIED
DO NOT OPEN SERVICE PERSONNEL.
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE"
WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS INTHE ;
LITERATURE ACCOMPANYING THE APPLIANCE,
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an
unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that
interference will not occur in a particular installation, If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures: er ie :
-- Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
~— Consult the dealer or an experienced radia / TV technician for help.
For the U.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of
cable entry as practical.
“tag

Kenwood KR-694 Specifications

General

Brand	Kenwood
Model	KR-694
Category	Stereo Receiver
Language	English