ENGLISH 47
SETTINGSSETTINGS
Sound adjustment
❏ Using the sound equalization
• The adjustments are memorized for each source
until you adjust the sound again. If the source is
a disc, the adjustments are stored for each of the
following categories.
– DVD/VCD
–CD
– MPEG1/MPEG2/MP3/WMA/WAV/AAC
• You cannot adjust the sound when the unit is in
standby.
Selecting a preset sound mode
1 Display the <Equalizer> screen.
On the Home screen:
2 Select a sound mode.
• You can change the page to display more
items by pressing [
]/[ ].
• You can also display the <Equalizer> screen by
pressing [
] on the source control screen.
Storing your own adjustments—Adjusting the
sound precisely
1 Select a sound mode. (See the left column.)
2 Select a band and adjust the level of the
selected band.
• You can adjust the level by dragging the slider
or using [J]/[K].
• Repeat this step to adjust the level of other
bands.
The adjustments are stored and <User> is
activated.
3 Adjust the sound.
<Q factor> Adjusts the width of the
frequency.
<Bass EXT> Activates ([ON])/deactivates
([OFF]) bass.
<SW LEVEL> Adjusts subwoofer level.*
• To apply the adjusted equalizer to all playback
sources, press [ALL SRC], then press [OK] to
confirm.
• To clear the adjustment, press [EQ INT].
* Not adjustable when <None> is selected for subwoofer on the
<Speaker Select> screen. (Page48)
❏ Setting the crossover network mode
Select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1 Turn off the AV source. (Page6)
2 Press FNC/ and volume + on the monitor
panel at the same time to display the
<X’over Network> screen.
3 Select the crossover network mode.
[2 way] Select this when connecting speakers
in a 2-way system (front/rear).
[3 way] Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Press [Yes].
2017KW-VEntryK.indb472017KW-VEntryK.indb47 2016/06/0221:222016/06/0221:22
To Next Page
Loading...
Need help?
General
