Kenwood L-A1 User Manual

e
Troub leshooting Before you contact your service representative, check the following list.
SOLUTIONS
¢
Press
the
SPEAKERS
OFF
key
to
turn
off
the
SPEAKERS
OFF
indicator.
¢
Reconnect
the
speaker
cords
according
to
the
procedure
PROBLEM
No sound
POSSIBLE CAUSES
e SPEAKERS OFF indicator is lit.
MAIN UNIT
e Speaker cords aren't properly connected.
18
REMOTE CONTROL UNIT
Volume has been turned down to zero.
Amplifier muting is on and the MUTING indicator is lit.
Audio cords are crossed or aren't properly connected.
The shorting pin is still connected to the REC terminal.
described in “ How to set up your new amplifier" on page
8.
Adjust the volume.
Press the MUTING key to turn off the MUTING indicator.
Check that the audio cords are properly connected.
Remove the shorting pin from the terminal.
ON/STAND BY indicator is blinking
rapidly and there is no sound from
the stereo
Speaker cords are short-circuited.
Press the POWER key to turn off the power before replac-
ing the speaker cords in their correct places. Then press
the POWER key again to turn the power back on.
No sound from one of the speakers
Youcan hear a strange sound when
the SOURCE selector knob (or the
SOURCE selector keys) is set to
PHONO
You get different volume levels
from the tuner and the record player
PROBLEM
Speaker cord is loose.
The record player's audio cord is not firmly inserted into
the PHONO jack.
The record player's grounding line is not properly
connected.
The output from the tuner is different from the output of
the record player.
The MM/MC mode is improperly set.
POSSIBLE CAUSES
Remote control unit doesn't work
Batteries are dead.
¢ You are too far away from the main unit or you are trying
to operate the remote contro! at too sharp an angle. Also
check that nothing is in the way.
Reconnect the speaker cords according to the procedure
described in “How to set up your new amplifier” on page
8.
Insert the audio cord firmly into the PHONO jack.
Connect the grounding line to the GND terminal on the
rear of the amplifier.
Adjust the volume.
Press the CARTRIDGE MM/MC key to properly set the
MM/MC mode.
SOLUTIONS
e Replace both batteries.
e Try using the remote control again, but within the area
described on page 11.
*
The
Kenwood
L-A1
uses
a
microprocessor
that
may
be
subject
to
external
noise
or
interference
which
would
cause
the
L-A1
to
function
improperly.
If
this
happens,
remove
the
power
cord
from
its
socket
and try the ampiifier once more.
* Do not use giues and fixatives to restore electrical connections as they may result in darnage to your amplifier. Solutions containing oils are particularly dangerous, as they may cause the distortion of
plastic parts.

Kenwood L-A1 Specifications

General

Brand	Kenwood
Model	L-A1
Category	Amplifier
Language	English