Kenwood TH-F7E User Manual

29
8 SELECTIVE CALL
DCS CODE ID SCAN
This function scans through all DCS codes to identify
the incoming DCS code on the received signal. You
may find this useful when you cannot recall the DCS
code that the other persons in your group are using.
1 While in DCS mode, press [F], [TONE] (1 s) to
start the DCS Code ID Scan function.
•To reverse the scan direction, turn the Tuning
control or press [ ]/ [ ].
•To quit the function, press [ ] or [PTT].
• When a DCS code is identified, the identified
code appears and blinks.
2 Press [ ] or [MNU] to program the identified
frequency in place of the current DCS code.
Otherwise, press [ ] if you do not want to
program the identified code.
•Turn the Tuning control or press [ ]/ [ ] while
the identified DCS code is blinking to resume
scanning.
Note:
◆ Received signals are monitored through the speaker while
scanning is in progress.
◆ DCS Code ID Scan does not scan the code if a signal is not
detected.
◆ If the DCS function is activated for both the A and B-band, the
scan speed may be slower.

Kenwood TH-F7E Specifications

General

Frequency Range TX	144-146 MHz, 430-440 MHz
Receiver System	Double conversion superheterodyne
Impedance	50 Ohms
Modes	FM, AM, WFM
Battery Type	Lithium-Ion
Receiver Sensitivity	0.16 µV (12dB SINAD)
Selectivity	12 kHz (-6 dB), 25 kHz (-60 dB)
Voltage	7.4 V
Dimensions	58 x 140 x 35 mm
Output Power	5 / 2.5 / 0.5 / 0.05 W
RF Power Output	5 W (VHF), 5 W (UHF)