KERN PFB Series User Manual

18 PFB-BA-e-1630
5.8.2 Linearization of non verifiable models (low resolution) and verifiable
models
Balance display
Operation
 Start balance by pressing . While the balance
carries out a self test, press until „F1 Unt“
appears
 Press repeatedly until “tECH“ appears
In case of verifiable models press the adjustment switch on the lower side of the
balance!
 Press , „Pin“ appears
 Press , and successively, „P1 Lin“
appears
 Press anew, „Pin“ appears again
 Press successively , and , „LoAd 0“
appears; after the apparition of the stability display
and the signal sound, „LoAd 1“ will be displayed
 Put on weight 1 (see table chap.6.8.1)
 Wait for the stability display and the signal sound
 „LoAd 2“ appears
 Remove weight 1 and put on the weight 2
 After the stability display and the signal sound „LoAd
3“ appears; remove weight 2 and put on weight 3
 After the stability display and the signal sound the
balance carries out a selftest. Remove the weight
during selftest. The balance changes into weighing
mode. Now the linearization is concluded
successfully.
ON
OFF

KERN PFB Series Specifications

General

Brand	KERN
Model	PFB Series
Category	Scales
Language	English