CKE-BA-e-2132 17
8 Basic mode
8.1 Switching on/off
Switching on:
Press the ON/OFF button.
Once the displays is lit, the scales autotest will be carried out.
Wait until the weight is displayed, the scales is ready for use.
Switching off:
Press and hold the ON/OFF button until the display goes off.
8.2 Ordinary weighing
Check the zero indication [>0<], and whenever required, zero by pressing the
TARE button.
Place the weighed material.
Wait until the stabilization indicator is displayed ( ).
Read out the weighing result.
Overload warninig
Always avoid any device overload higher than the stipulated maximum
load (Max), deducting the tara from the existing load. This could damage
the device.
The exceeded maximum load is indicated with . Reduce the scales
load or reduce the initial load.
8.3 Weighing with tara
8.3.1 Taring
The empty weight of any vessel used for weighing can be tared, pressing the button
which results in displaying the net weight of the weighed material during consecutive
weighing processes.
Place the scales vessel on the scales plate.
Wait until the stabilization indicator is displayed ( ), and press TARE. The
vessel weight will be saved in the scales memory. The stabilization indica-
tor is displayed ( ) and “TARE” symbol will be displayed.
“TARE” indicates all displayed weight values are net values.
Weigh the weighed material.
Wait until the stabilization indicator is displayed ( ).
Read out the net weight.
To Next Page
Loading...
Need help?
General
