KERN TCKE 300-3-A Operating Instruction

CKE-BA-e-2132 21
10 Check counting
The scales enables to weigh materials to the specific target number of pieces in the
preset tolerance range. This function enables also to check if the weighed material
belongs to the preset tolerance range.
Achieving the target value is indicated by an audible signal (if enabled in the menu)
and a visual signal (tolerance symbol , , )
Visual signal:
Tolerance symbols provide the following information:
The target number of pieces above the preset tolerance
The target number of pieces in the preset tolerance range
The target number of pieces below the preset tolerance
Audible signal:
The audible signal depends on the
<beeper check> menu item, see chapter 11.2.1.
You can choose:
Tolerance check type Audible signal settings
Ch-ok
The audible signal sounds
when the target number of
pieces belongs to the preset
tolerance range
off
The audible signal is off
Slow beep
Slow
Standard
beep
Standard
Fast beep
Fast
Cont. beep
Continuous
Ch-lo
The audible signal sounds
when the target number of
pieces is lower than the
preset tolerance range
off
The audible signal is off
Slow beep
Slow
Standard
beep
Standard
Fast beep
Fast
Cont. beep
Continuous

KERN TCKE 300-3-A Specifications

General

Brand	KERN
Model	TCKE 300-3-A
Category	Scales
Language	English