Features of your vehicle
1204
Turn signals and lane change
signals
The ignition switch must be on for the
turn signals to function. To turn on the
turn signals, move the lever up or
down (A). The green arrow indicators
on the instrument panel indicate which
turn signal is operating. They will self-
cancel after a turn is completed.
If the indicator continues to flash
after a turn, manually return the lever
to the O/OFF position.
To signal a lane change, move the
turn signal lever slightly and hold it in
position (B). The lever will return to
the O/OFF position when released.
If an indicator stays on and does not
flash or if it flashes abnormally, one of
the turn signal bulbs may be burned
out and will require replacement.
✽✽
NOTICE
If an indicator flash is abnormally
quick or slow, a bulb may be burned
out or have a poor electrical connec-
tion in the circuit.
WARNING
• Do not place any accessories,
stickers or tint the windscreen.
• Have the windscreen glass
replaced from an authorised
dealer.
• Do not remove or impact relat-
ed parts of the high beam
assist.
• Be careful that water doesn’t
get into the high beam assist
unit.
• Do not place objects on the
dashboard that reflects light
such as mirrors, white paper,
etc. The system may malfunc-
tion if the sunlight is reflected.
• At times, the high beam assist
system may not work proper-
ly, always check the road con-
ditions for your safety. When
the system does not operate
normally, manually change
the high beam and low beam.
OBK049051N
OAM049045
Type Aâ– Type A
â– Type B
OAM049045R-1
â– Type C
To Next Page
Loading...
Need help?
General
