Driving your vehicle
626
To drive over the preset speed limit
you must depress hard on the accel-
erator pedal (more than approxi-
mately 82%) until the kick down
mechanism works with a clicking
noise. Then the set speed limit will
blink and chime will sound until you
return the vehicle speed within the
speed limit.
✽✽
NOTICE
• Depressing the accelerator pedal
less than approximately 50%, the
vehicle will not speed over the pre-
set speed limit but maintain the
vehicle speed within the speed
limit.
• A clicking noise heard from the
kick down mechanism by depress-
ing the accelerator pedal fully is a
normal condition.
To turn off the speed limit con-
trol, do one of the following:
• Press the speed limit button
once again.
• Press the cruise button (If you
press cruise button, the cruise sys-
tem will turn on).
• Turn the ignition off.
If you press the cancel button once,
the set speed limit will cancel, but it
will not turn the system off.
If you wish to reset the speed limit,
push the RES+ button or SET- button
to the desired speed.
OPS053061L
To Next Page
Loading...
Need help?
General
