731
What to do in an emergency
10. With the ignition switched on or
engine start/stop button position
on: Switch on the compressor
and let it run for approximately 3
minutes to fill the sealant. The
inflation pressure of the tyre after
filling is unimportant.
11. Switch off the compressor.
12. Detach the hose from the sealant
bottle connector and from the
tyre valve.
Return the Tyre Mobility Kit to its
storage location in the vehicle.
Distributing the sealant
13. Immediately drive approximately
7~10km (4~6miles or, about
10min) to evenly distribute the
sealant in the tyre.
WARNING
Carbon monoxide poisoning
and suffocation is possible if
the engine is left running in a
poorly ventilated or unventilat-
ed location (such as inside a
building).
OTAM061030
CAUTION
Do not exceed a speed of 60
km/h (35 mph). If possible, do
not fall below a speed of 20
km/h (12 mph).
Whilst driving, if you experience
any unusual vibration, ride dis-
turbance or noise, reduce your
speed and drive with caution
until you can safely pull off of
the side of the road. Call for
road side service or towing.
When you use the Tyre Mobility
Kit, the wheel may be stained by
sealant. Therefore, remove the
wheel stained by sealant and
have the vehicle inspected at a
professional workshop. Kia rec-
ommends to visit an authorised
Kia dealer/service partner.
To Next Page
Loading...
Need help?
General
