855
AUTOMATIC TRANSAXLE FLUID (IF EQUIPPED)
Checking the automatic
transaxle fluid level
The automatic transaxle fluid level
should be checked regularly.
Keep the vehicle on level ground with
the parking brake applied and check
the fluid level according to the follow-
ing procedure.
1. Place the shift lever in N (Neutral)
position and confirm if the engine
is running at normal idle speed.
✽✽
NOTICE
Insert the level gauge, after checking
the automatic transaxle fluid level. In
the direction referred in the picture.
2. After the transaxle is warmed up
sufficiently [fluid temperature
70~80°C (158~176°F)], for exam-
ple by 10 minutes usual driving,
move the shift lever through all
positions then place the shift lever
in N(Neutral) or P(Park) position.
3. Confirm if the fluid level is in the
"HOT" range on the level gauge. If
the fluid level is lower, add the
specified fluid from the fill hole. If
the fluid level is higher, drain the
fluid from the drain hole.
4. If the fluid level is checked in cold
condition [fluid temperature
20~30°C (68~86°F)], add the fluid
to the "COLD" line and then
recheck the fluid level according to
the above step 2.
Maintenance
OSA077009
HOT
COLD
CAUTION
If you insert the level gauge in
the wrong direction, it can
cause deformation (or damage)
to level gauge.
OYB076014
To Next Page
Loading...
Need help?
General
