OPERATING 5-19
DEALING OF SINGLE-DOUBLE
ACTING VALVE
WARNING
To avoid personal injury:
When not using the P.T.O axle,
please cover it after applying
grease on it.
When connecting or disconnect-
ing the coupler, take away pres-
sure after stopping the engine.
Do not use hands to check oil leak-
age
615O523A
The lowering speed of the 3-pint hitch
can be controlled by adjusting the 3-point
lowering speed knob.
CAUTION
To avoid personal injury:
Fast lowering speed may cause
damage or injury. Lowering speed
of implement should be adjusted
to two or more seconds.
(1) 3-point hitch lowering speed knob
(A) Lock (
) Fast ( ) Slow
3-POINT HITCH LOWERING SPEEDMIXED CONTROL
In draft control, when draft decreases,
the implement automatically lowers to in-
crease draft. However, the implement
sometimes lowers too much. To limit the
degree, the implement can be lowered,
set the position control lever at the low-
est working depth desire for the
implement. Lower the draft control lever
to the point where the implement is at the
desired depth.
This stops the implement from going too
deep and causing loss of traction and
ground speed.
615O522A
(1) Ground Surface (2) Soft Soil
(3) Implement Penetration Limit
615O524A
To Next Page
Loading...
Need help?
General
