6-20 DK35/40/450L
615O628A
(1) Oil Filter Cartridge
REPLACING ENGINE OIL FILTER
IMPORTANT
To prevent serious damage to the
engine, use only a DAEDONG
genuine filter.
EVERY 200 HOURS
1. Remove the oil filter.
2. Put a film of clean engine oil on the
rubber seal of the new filter.
3. Tighten the filter quickly until it con-
tacts the mounting surface.
Tighten filter by hand an additional half
turn only.
4. After the new filter has been replaced,
the engine oil normally decreases a
little. Make sure that the engine oil does
not leak through the seal and be sure
to check the oil level on the dipstick.
Then, replenish the engine oil up to
the prescribed level.
CAUTION
To avoid personal injury:
Be sure to stop the engine be-
fore changing oil filter cartridge.
Allow engine to cool down
sufficiently, oil can be hot and can
burn.
615O629A
REPLACING HYDRAULIC OIL FILTER
CAUTION
To avoid personal injury:
Be sure to stop the engine before
changing the oil filter cartridge.
Allow engine to cool down suffi-
ciently, oil can be hot and can burn.
The oil filter cartridge must be cleaned
every 300 service hours. It is located to
the right of the tractor.
1. Remove the drain plug at the bottom of
the transmission case and drain the
oil completely into the oil pan.
2. After draining reinstall the drain plug.
(1) Drain Plug