12
3. INSTALLATION AND TRANSPORTATION
3.1 Installation
Pay attention to the following items during installation:
(1) Please install the machine on the flat and solid ground. Make sure bottom of the generator
contacts ground evenly. Error may occur due to generator vibration.
(2) If it is necessary to run the machine on the inclined ground, make sure the side with radiator
upwards and inclination angle within 10°. Engine may face overheat due to bad working of water
temperature switch or mixed air in the cooling water.
(3) Keep the machine at least 200-300mm away from walls upon installation. Keep radiator air
vent and engine inlet/ exhaust vent upwards, preventing them from any jam. Otherwise,
temperature may rise or cooling airflow may be reduced, thus causes overheat of engine or
reduction of rotation speed. In addition, temperature of exhaust or increase of load may also lead
to shorter duration.
Don’t put any barrier on the exhaust outlet, vent, or muffler exhaust vent.
(4) Run the machine in the place free of moisture, dust and rubbish and with free air.
Electricity leakage causes electric shock. If air vent of radiator is jammed, overheat of engine
may occur.
(5) Place the generator near to working equipments like motor, lamps and etc.
Long line reduces efficiency because of large resistance and electricity loss. In addition, the
electricity fee turns more.
Radiator side
Fixed bolt
10°
1m
17cm
Exhaust outlet
Muffler exhaust vent
Radiator side
Inlet
Fixed bolt
Wall
To Next Page
Loading...
Need help?
General
