EasyManuals Logo
Home>Kipor>Inverter>KDE40ST3

Kipor KDE40ST3 User Manual

Kipor KDE40ST3
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
25
Temperature
Charging ratio %
20 -10 0
100 1.28 1.30 1.29
90 1.26 1.28 1.27
80 1.24 1.26 1.25
75 1.23 1.25 1.24
Remarks: ±0.01 tolerance is possible.
Charge the battery immediately when the charging ratio is lower than 75%.
(3) Charging attentions
When charge the equipped storage battery:
Disconnect the distribution line of battery before charging.
Charge at ventilated place.
Disconnect the negative wire first when disconnecting the distribution line of battery.
(If there is any tool between positive pole and machine, electrical spark may be produced,
leading to extreme risk.)
When connecting the distribution line of storage battery, connect the positive wire first and
negative wire finally.
Ensure sufficient ventilation during charging.
Keep away from ignition source or forbid any actions producing electrical spark because
charging produces inflammable gas.
Re-charge the storage battery after intervals if storage battery is extremely hot, i.e. electrolyte
temperature is above 45.
Stop charging immediately as storage battery is full.
There are following disadvantages if the charging continues when storage battery is full.
1) Over-heat of storage battery
2) Reduction of electrolyte
3) Abnormality of storage battery
Connect the positive wire prior to negative wire.
Incorrect wiring may damage the engine.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kipor KDE40ST3 and is the answer not in the manual?

Kipor KDE40ST3 Specifications

General IconGeneral
BrandKipor
ModelKDE40ST3
CategoryInverter
LanguageEnglish

Related product manuals