KitchenAid KDHE704DSS0 Installation Instructions

Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.
Connect to Water Supply
Be sure rubber washer is properly seated in fitting. Slide the
3/4"fitting of the 90° elbow up to the valve and hand tighten to
avoid cross-threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
1/4to 1/2turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Place paper towel under 90° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation of this step.
Visit www'kitchenaid'c°m/watersupply under FAQ tab.
NOTE: Do not use Teflon ®tape with compression fittings.
Connect to Drain
Place towel under drain hose to catch any water in drain hose.
Place the small drain hose clamp onto the small end of the drain
hose. Push the new drain hose into the rubber drain hose
connector up to the drain hose stop.
Using pliers, squeeze open the small drain hose clamp and slide
onto connector between stops.
Hose clamp final position
Drain hose
Rubber drain hose
connector
Small clamp
Stop
Stop
Drain hose stop
(
After hose is connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.kitchenaid.com/drain under FAQ tab.
21

KitchenAid KDHE704DSS0 Specifications

General

Style	built-in dishwashers
Color	stainless-steel
Noise level	39 decibels
Control Type	electronic
Delay Start	yes
Child Lock	no
Load Sensor	yes
Number of Racks	3
Cycle Signal	no
Water Filter	yes
Food Disposer	no
Sanitize Settings	no
Current	15 amperes

Weight and Dimensions

Depth	24.75 inches