KitchenAid KDHE704DSS0 Installation Instructions

Make Drect Wre Electr cal Connect on
NOTE: If the power supply cord was connected earlier, proceed to
"Secure Dishwasher in Cabinet Opening" section.
Option B, Direct Wire:
Route cable so that it does not touch dishwasher motor or lower
part of dishwasher tub. Pull cable through UL Listed/CSA
Approved strain relief in terminal box. Strain relief is not supplied
with the dishwasher. Owner must purchase a 7/8"screw-in type
strain relief.
Select UL Listed/CSA Approved twist-on wire connectors (not
included) rated to connect your household wiring to 16-gauge
dishwasher wiring.
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Direct WiremConnect
ground wire
o
\-J_ I _:_.,_i'_Y wi rd f"
_ashe 1
Ground /
Form bare ground wire into a U-shaped hook. Wrap ground wire
hook clockwise around ground connector screw and under the
washer. Securely tighten ground connector.
NOTE: Twist on UL Listed/CSA Approved wire connector. Gently
tug on wires to be sure both are secured.
22

KitchenAid KDHE704DSS0 Specifications

General

Style	built-in dishwashers
Color	stainless-steel
Noise level	39 decibels
Control Type	electronic
Delay Start	yes
Child Lock	no
Load Sensor	yes
Number of Racks	3
Cycle Signal	no
Water Filter	yes
Food Disposer	no
Sanitize Settings	no
Current	15 amperes

Weight and Dimensions

Depth	24.75 inches