7
K13015FOM_Ver.0406
KNOW YOUR AIR COMPRESSOR (See Fig. A, p. 4)
Before attempting to use this product, familiarize yourself with all
operating features and safety rules.
AIR OUTLET
The air outlet is located on the front of the compressor. Its pressure
is adjustable for each use from 40 to 135 psi. Pressure is adjusted
by simply rotating the knob arrow to the desired pressure setting or
use icon.
OIL-FREE UNIVERSAL MOTOR
Your air compressor features permanently lubricated bearings.
SAFETY VALVE
The safety valve is designed to automatically release air if the air
receiver pressure exceeds the preset maximum.
TANK PRESSURE GAUGE
The tank pressure gauge indicates the pressure of the air in the
tank.
Estimated Time of Assembly: 2 minutes
Tools Required: 9/16 in., 5/8 in. and 11/16 in. wrenches
(not included)
1) UNPACKING
• Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list
are included.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• If any parts are damaged or missing, please call
1-866-242-4298 for assistance, or send a detailed FAX
request to 1-803-328-0375.
The shipping pallet is not designed as a
base for an operating compressor.
Remove the compressor from the shipping pallet or carton and
place it on the floor or a hard, level surface. The compressor must
be level to ensure proper drainage of the moisture in the tank.
PACKING LIST
Air Compressor
Handle
Handle knobs (2)
Electrical cable shell
Coil Hose
Blower Attachment with Safety Nozzle
Air Chuck
Inflation Nozzles (2)
Inflation Adapter
Inflation Needle
1/4 in. NPT Quick Coupler
1/4 in. NPT Male Connector Fitting (2)
1/4 in. NPT Female Connector Fitting
Tire Gauge
Seal Thread Tape
Operator’s Manual
If any parts are damaged or missing do
not operate this tool until the damaged or missing parts are
replaced. Failure to do so could result in possible serious
personal injury.
Do not attempt to modify this tool or create
accessories not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal injury.
To prevent accidental starting that could
cause serious personal injury, always unplug the tool when
assembling parts.
2) ASSEMBLING THE HANDLE
Slightly stretch out the handle and lower it onto the
compressor body, as shown in (Pic. 1). The handle should
line up with the guides on each side of the compressor.
Insert the two handle knobs into the holes on the sides of
the handle (Pic. 2). Tighten firmly in a clockwise direction to
secure the handle in position (Pic. 3).
3) ASSEMBLING THE ELECTRICAL CABLE SHELL
Align the 4 holes of the shell with the 4 hooks located on
the underside of the compressor (Pic. 4).
Press the sides of the shell inwards as shown in (Pic. 5).
Then push the shell forwards. The shell will click into
position when it is correctly located (Pic. 6).
ASSEMBLY
FEATURES
ASSEMBLY
CAUTION:
WARNING:
WARNING:
WARNING:
Pic. 3
Pic. 2
Pic. 1
To Next Page
Loading...
Need help?
General
