.
OPERATION
OPERATION
PRECAUTIONS ON SLOPE
BE CAREFUL OF FUEL LEVEL
If the fuel level in the fuel tank becomes low when the machine is working on slopes, the engine may suck in air
because of the angle of the machine or the swaying of the machine. This may make the engine stop, so be careful
not to let the fuel level in the fuel tank become too low.
When working on slopes with an angle of more than 20°, if the
fuel level on the fuel gauge enters the red range, add fuel
immediately.
(A): Red range
(B): Green range
BE CAREFUL OF OIL LEVEL
When operating machine on sloped areas of more than 20°, fill all appropriate components with oil to H level.
PRECAUTIONS WHEN ENGINE STOPS ON SLOPE
If the engine stops while working or traveling on a hill, immediately depress the brake pedal to bring the machine to
a complete stop.
METHOD OF USING BRAKES
The following actions cause premature damage to the brakes, so avoid such operations.
Using emergency brake at full speed
Using brake with engine running at full speed in first gear (F1, R1) (Machine stall condition)
REMARK
Always depress the decelerator pedal to lower the engine speed before actuating the brakes.
PROHIBITED TO KEEP THE DOOR OPEN DURING OPERATIONS
Always keep the door closed when traveling or carrying out operations.
If the door is open, there is danger of damage from obstacles or strong vibration.
IT IS PROHIBITED TO MODIFY THE CAB GLASS IN ANY WAY THAT WILL OBSTRUCT THE VIEW
For safety reasons, do not install anything on the cab glass that will obstruct the view.
Always keep the glass clean to ensure safety during operations.
3 - 139
To Next Page
Loading...
Need help?
General
