acquired was from Output 2).
3. Press the EDID SELECT button repeatedly until the required EDID is
indicated based on the patterns described above.
4. Press the EDID READ button.
The relevant LEDs flash in a pattern for a few seconds as follows:
Slowly and then no longer lights. The EDID was successfully read.
Quickly and then no longer lights. The EDID was not read and the default
EDID was stored.
5.2.1 Disabling/Enabling Deep Color Support
You can disable EDID deep color support to prevent signal deterioration when
using long twisted pair cables on INPUT 2.
To disable deep color and acquire EDID:
1. Disconnect the power.
2. Connect the output or outputs from which you want to acquire the EDID.
3. Connect the power while pressing the EDID READ button.
4. Perform steps 3 through 5 in Section
5.2.
To enable deep color and acquire EDID:
1. Disconnect the power.
2. Connect the output or outputs from which you want to acquire the EDID.
3. Connect the power while pressing the EDID SELECT button.
4. Perform steps 3 through 5 in Section
5.2.
5.3 Connecting to the VM-114H2C via RS-232
You can connect to the VM-114H2C via an RS-232 connection using, for
example, a PC. Note that a null-modem adapter/connection is not required.
To connect to the VM-114H2C via RS-232:
• Connect the RS-232 9-pin D-sub rear panel port on the VM-114H2C unit
via a 9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to
pin 5 need to be connected) to the RS-232 9-pin D-sub port on your PC
5.4 RS-232 and IR Control and Pass-through
The VM-114H2C can be controlled via RS-232 and infrared. Depending on how
the RS-232 and IR connections are configured, the device will either respond to
control signals or transparently pass them through to another receiver or
transmitter. Three examples in Sections
5.4.2.1, 5.4.2.2 and 5.4.2.3 of various
configurations illustrate this functionality.
To Next Page
Loading...
Need help?
General
