KRAMER: SIMPLE CREATIVE TECHNOLOGY
10
1 Switch OFF the power on each device before connecting it to your VM-3VN. After connecting your VM-3VN, switch on its
power and then switch on the power on each device
2 You do not have to connect all the outputs
Figure
6:
Connecting the VM-3VN Video Distributor
Composite Video
Recorder 3
Composite Video
Recorder 1
Composite
Video Player
To connect' the
VM-3VN,
as illustrated in the example in
Figure
6, do the
following:
1. Connect the composite video source to the INPUT BNC connector.
2. Terminate the input
by
ensuring that the TERM switch is pressed to the IN
position.
3. Connect the OUT BNC connectors (from 1 to 3) to up to three composite
video acceptors".
4. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity (not illustrated in
Figure
6).
5. If required, adjust output equalization (EQ) and signal level (LEVEL)
by
turning the appropriate trimmer with a small screwdriver.
5.3 Connecting Your VM-3VN Video DA
Connecting Your Distribution Amplifier
To Next Page
Loading...
Need help?
General
