KRUPS SERIE EA90
18
Important: You must remember to run the install function every time you change the cartridge as soon as you can.
!
INSTALLING THE FILTER (LATER)
n Press “Later” and confirm.
n Remove the water tank from inside the right door.
n Fill the water tank and then put it back in the machine.
n Close the right door again.
INSTALLING THE FILTER (NOW)
n Filter installation: press “Now“.
n Open the right door of the machine and remove the water tank.
n Remove the filter cartridge and the fitting accessory from the packaging and
assemble the cartridge fitting accessory as illustrated.
n Set the month when the cartridge is fitted (position 1 on the illustration, left
side figure in the opening) by turning the grey ring located on the upper end
of the filter. The month when the cartridge should be replaced is indicated
in position 2 on the illustration.
n Attach the cartridge fitting accessory to the filter cartridge as shown in the
illustration.
n Lift the removable lid off the tank.
n Screw the filter cartridge into the screw thread at the bottom of the water
tank: place the filter cartridge into the thread and screw in the cartridge.
Remove the cartridge fitting accessory from the filter cartridge.
n Fill the water tank and then put it back in the machine.
n Close the right door. Your machine will fill the filter cartridge.
n Your machine will fill the filter cartridge with water. This will take a few
seconds. You will then be asked to empty the larger drip tray.
Note: The filter cartridge must be replaced approximately every 50 litres of water
or at least every 2 months. Your machine tells you how many days or litres remain
before you need to change the cartridge. (see Section 7, “Info menu”)
!
h
h
h
h
1
1
2
2
IFU_EN_KR_COFFEEMAKER_8020000082.qxp_Mise en page 1 22/05/2017 17:22 Page18
To Next Page
Loading...
Need help?
General
