Krups XP442C11 User Manual

76
ENGLISH
DESCALING
IMPORTANT! Warning! Do not clean any parts of this appliance in a
dishwasher.
The machine can be descaled at any time, even if the descaling light is not on. However,
the coffee machine auto counts the use cycles and gives the alert when the machine must
be descaled : when the 1 cup espresso button white light and orange light ash in turn
and 2 cups espresso button white light keep on, the machine needs to be descaled.
1. Prepare the descaler in accordance with the manufacturer’s instructions, add to the water
tank and ll with approx. 750 ml drinking water (2). Place the tank in the machine (3).
2. Place a receptacle with a capacity of at least 1 liter underneath the spouts.
3. Insert the lter holder without lter.
4. Press 1 cup and 2 cup espresso buttons at the same time for 3 seconds to go to
auto descaling program. white light and white light ash in turn. Release the buttons,
machine will go to descaling status automatically. Water pump works 10 seconds, stops
120 seconds, keeps it in cycles until water tank will be empty.
5. Once descaling nishes, 2 espresso buttons white light keep on.
6. Pour drinking water in the tank and rinse the whole water owing system (without using
coffee, repeat making coffee steps, making hot water and steaming).
 Steam nozzle : To prevent milk from drying inside the nozzle, please clean it after each
use. To do this, follow the steps for foaming the milk, replacing 100 ml of milk with 60
ml of water. After turning off the steam, quickly and carefully clean the steam nozzle
using a damp sponge (in order to remove any residue). Pull the tube of the steam nozzle
downwards. Carefully clean the steam nozzle with lukewarm water (28) (29). Fit the tube
back onto the steam nozzle.
IMPORTANT! After descaling, rinse 2-3 times using clean water (no coffee),
as described in the “FIRST USE” paragraph. Do not forget to rinse the
nozzle. The appliance is now descaled and ready for use again.
No repairs on the coffee machine will be covered by the guarantee in case of:
– no descaling carried out,
– limescale build-up,
– accessories cleaned in a dishwasher.
GUARANTEE
This appliance carries a manufacturer’s 2 year guarantee. This product has been designed
for domestic use only. Any commercial use, inappropriate use or failure to comply with the
instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
Any repairs that have to be carried out due to a build-up of limescale shall not be covered
by the guarantee.
For any after-sales problem or for spare parts, please contact an approved service centre.
TROUBLESHOOTING
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The coffee is very moist. You have not used enough
coffee.
Add more coffee.
The espresso ows too
slowly.
The coffee is too ne, too
coarse or too mealy.
Choose slightly larger
coffee grounds.
The lter holder is dirty. Clean your lter holder
using the instructions in the
section: CLEANING AND
MAINTENANCE
The head of the lter holder
is clogged.
When the appliance has
cooled, clean the grill
through which the water
ows using a damp sponge.
Your machine is calcied. Descale your machine
following the user
instructions provided.
There is too much coffee. Observe the maximum
limits when lling the lter.
A continuous ow of water
pours from the lter holder
after making an espresso.
Your machine is becoming
calcied because the water
is particularly hard.
Descale your machine
immediately following the
user instructions provided.

Krups XP442C11 Specifications

General

Brand	Krups
Model	XP442C11
Category	Coffee Maker
Language	English