19 STORAGE 240
– Raise the rear of the motorcycle with lifting gear. ( p. 165)
– Raise the front of the motorcycle with lifting gear. ( p. 166)
– Cover the motorcycle with a porous sheet or blanket.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Since the engine cannot warm
up properly, the water vapor produced during combustion condenses and causes
valves and exhaust system to rust.
19.2 Preparing for use after storage
401059-01
– Take the motorcycle off of the front wheel stand. ( p. 166)
– Remove the rear of the motorcycle from the lifting gear. ( p. 165)
–
Recharge the battery. x ( p. 203)
–
Install the battery. x ( p. 202)
– Set the clock with SET CLOCK. ( p. 95)
– Perform checks and maintenance measures when preparing for use. ( p. 116)
– Take a test ride.
To Next Page
Loading...
Need help?
General
