15 ELECTRICAL SYSTEM 99
602762-11
–
Position the headlight mask and fix it with rubber straps
.
The holding lugs engage.
– Position the brake line and wiring harness. Put the clamp on and mount and
tighten screw
.
Finishing work
– Check the headlight setting. ( p. 100)
15.7 Changing the headlight bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
– Remove the headlight mask with the headlight. ( p. 98)
B01562-10
Main work
–
Turn protection cap
together with the underlying bulb socket counterclockwise
all the way and remove it.
–
Pull lamp socket
of the parking light out of the reflector.
B01563-10
–
Pull out headlight bulb
.
– Insert the new headlight bulb.
Headlight (HS1 / socket BX43t) ( p. 125)
– Insert the protection cap with the bulb socket into the reflector and turn it clock-
wise all the way.
Info
Ensure that the O-ring
is seated properly.
– Insert the lamp socket of the parking light into the reflector.
Finishing work
– Refit the headlight mask with the headlight. ( p. 98)
– Check the headlight setting. ( p. 100)
15.8 Changing the turn signal bulb (All EXC models)
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
To Next Page
Loading...
Need help?
General
