7 SPEEDOMETER 26
7.17 Display mode SPEED/TR2 (trip master 2)
400324-01
– Repeatedly press the button briefly until TR2 appears at the top right of the dis-
play.
TR2 (trip master 2) runs constantly and counts up to 999.9.
Press the button
for 2–3 seconds.
Clears the values TR2 and A2.
Briefly press the
button .
Next display mode
Press the button
for 2–3 seconds.
Reduces value of TR2.
Briefly press the
button .
Reduces value of TR2.
7.18 Setting TR2 (trip master 2)
400324-01
Condition
• The motorcycle is stationary.
– Repeatedly press the button briefly until TR2 appears at the top right of the dis-
play.
– Press the button for 2–3 seconds until TR2 flashes.
The displayed value can be set manually with the button and the button . This is a
very practical function when riding using the road book.
Info
The TR2 value can also be corrected manually during the journey with the but-
ton and the button .
If 999.9 is exceeded, the value of TR2 is automatically reset to 0.0.
Press the button
for 2–3 seconds.
Increases value of TR2.
Briefly press the
button .
Increases value of TR2.
Press the button
for 2–3 seconds.
Reduces value of TR2.
Briefly press the
button .
Reduces value of TR2.
Wait 10–12 sec-
onds
Saves and closes the Setup menu
7.19 Display mode SPEED/A1 (average speed 1)
400325-01
– Repeatedly press the button briefly until A1 appears at the top right of the dis-
play.
A1 (average speed 1) shows the average speed calculated using TR1 (trip master 1) and
S1 (stop watch 1).
The calculation of this value is activated by the first impulse of the wheel speed sensor
and ends 3 seconds after the last impulse.
Press the button
for 2–3 seconds.
Displays of TR1, A1 and S1 are reset to 0,0.
Briefly press the
button .
Next display mode
Press the button
for 2–3 seconds.
No function
Briefly press the
button .
No function
To Next Page
Loading...
Need help?
General
