KTM 125 SX 2004 User Manual

ENGLISH
37
Check/set distance of the magnetic sensor
The distance between the magnet 2 and the sensor 1 must be 2-4 mm,
otherwise malfunctions on the speedometer might occur.
This distance can be corrected by screwing the sensor
1 in or off.
Replacing the headlight lamp/parking light lamp
Loosen both rubber bands and tilt the headlight mask to the front. Pull the
parking light lamp with holder
3 carefully out of the reflector. Pull
connector
4 off the headlamp and remove rubber cap 5. Disengage retai-
ning clip and take the bulb out of the reflector. When changing the par-
king-light lamp, simply pull it out of the holder.
Insert a new lamp such that the noses
6 engage in the recesses 7 .When
doing so, do not touch the glass body of the lamp so that it remains free
from fat. Engage retaining clip, mount rubber cap and connector. If the par-
king-light lamp is to be replaced, simply insert it in the holder. Reinsert par-
king-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and fix
the mask by means of the rubber bands.
1
2
1
5
4
3
7
6

KTM 125 SX 2004 Specifications

General

Engine Type	Single-cylinder, 2-stroke
Displacement	124.8 cc
Cooling System	Liquid-cooled
Starter	Kickstarter
Transmission	6-speed
Front Suspension	WP USD 48 mm
Rear Suspension	WP PDS shock absorber
Front Brake	Single 260 mm disc
Rear Brake	Single 220 mm disc
Front Tire	80/100-21
Rear Tire	100/90-19
Seat Height	925 mm
Ground Clearance	385 mm
Dry Weight	88 kg
Bore x Stroke	54 mm x 54.5 mm
Ignition	Kokusan digital
Wheelbase	1, 471 mm
Fuel Capacity	7.5 liters
Fuel System	Carburetor
Frame	Chromium-Molybdenum steel central-tube frame