SERVICE WORK ON THE CHASSIS 11
51
– Press the dust boots back into the installation position.
– Remove the excess oil.
Finishing work
– Install the fork protector. ( p. 51)
– Remove the motorcycle from the lift stand. ( p. 49)
11.5 Removing the fork protector
F00024-10
–
Remove screws
1
on the left fork leg. Take off the clamp.
–
Remove screws
2
on the left fork leg. Take off the left fork
protector.
–
Remove screws
3
on the right fork leg. Take off the right fork
protector.
11.6 Installing the fork protector
F00024-11
– Position the fork protection on the left fork leg. Mount and
tighten screws
1
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
– Position the brake line and clamp. Mount and tighten
screws
2
.
– Position the fork protector on the right fork leg. Mount and
tighten screws
3
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
11.7 Removing the fork legs
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 49)
– Remove the front wheel. ( p. 95)
S05330-10
Main work
–
Remove screws
1
and take off the clamp.
–
Remove screws
2
and take off the brake caliper.
– Allow the brake caliper and brake line to hang loosely to the
side.
Info
Do not actuate the hand brake lever when the front
wheel is removed.
To Next Page
Loading...
Need help?
General
