13 SERVICE WORK ON THE CHASSIS 104
L01489-01
– Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding piece:
–
Change the chain sliding piece. x
– Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
– Tighten the chain sliding piece.
Guideline
Remaining screws, chassis M8 25 Nm
(18.4 lbf ft)
13.17 Checking/correcting the fluid level of the hydraulic clutch
Info
The fluid level rises with increasing wear of the clutch facing discs.
Do not use brake fluid.
– Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
To Next Page
Loading...
Need help?
General
