KTM 25 EXC 2016 - Checking the Headlight Setting

3 WORK 15
3.12 Refitting the headlight mask with the headlight
M00589-11
Main work
(All EXC models)
–
Connect plug-in connectors

.
M00590-11
(XC-W, 300 XC‑W Six Days US)
–
Connect plug-in connector

.
602762-11
–
Position the headlight mask and fix it with rubber straps

.
The holding lugs engage.
– Position the brake line and wiring harness. Put the clamp on and mount and
tighten screw

.
Finishing work
– Check the headlight setting. ( p. 15)
3.13 Checking the headlight setting
400726-10
– Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically a distance

away from the wall.
Guideline
Distance

5 m (16 ft)
– The rider now sits down on the motorcycle.
– Switch on the low beam.
– Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
– Adjust the headlight range. ( p. 16)