PREPARING FOR USE 8
39
(All EXC models)
– Adjust the free travel of the hand brake lever. ( p. 99)
(All XC‑W models)
– Adjust the basic position of the hand brake lever. ( p. 100)
– Adjust the basic position of the foot brake lever. ( p. 105)
– Set the basic position of the shift lever. ( p. 139)
– Get used to handling the motorcycle on a suitable surface before undertaking a more challenging trip.
Info
When off road, it is recommended that you are accompanied by another person on another vehicle so
that you can help each other.
– Try also to ride as slowly as possible and in a standing position to get a better feeling for the motorcycle.
– Do not make any off-road trips that exceed your ability and experience.
– Hold the handlebar firmly with both hands and keep your feet on the footrests when riding.
– If you carry luggage, make sure you secure it firmly as close as possible to the center of the vehicle and
ensure even weight distribution between the front and rear wheels.
Info
Motorcycles react sensitively to any changes of weight distribution.
– The maximum permissible overall weight and the maximum permissible axle loads must not be exceeded.
Guideline
Maximum permissible overall weight 335 kg (739 lb.)
Maximum permissible front axle load (All 250 mod-
els)
148 kg (326 lb.)
Maximum permissible front axle load (All 300 mod-
els)
147 kg (324 lb.)
Maximum permissible rear axle load 190 kg (419 lb.)
– Check the spoke tension. ( p. 116)
Info
The spoke tension must be checked after half an hour of operation.
– Run the engine in. ( p. 39)
8.2 Running in the engine
– During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
During the first 3 operating hours < 70 %
During the first 5 operating hours < 100 %
– Avoid fully opening the throttle!
– Check the idle speed regularly.
Guideline
Idle speed 1,400 … 1,500 rpm
Info
The idle speed may change during the run-in time.
To Next Page
Loading...
Need help?
General
