KTM 390 Duke Series 2018 User Manual

3 WORK
8
3.5 Removing the passenger seat
H01991-10
–
Insert the ignition key in seat lock
1
and turn it clockwise.
– Raise the rear of the seat, push it towards the rear, and lift it
off.
– Remove the ignition key from the seat lock.
3.6 Mounting the passenger seat
H01992-01
–
Attach hooks
1
on the passenger seat to seat mounting
2
on the subframe, and lower it at the rear while pushing for-
ward.
– Press passenger seat downward until it clicks into place.
Warning
Danger of accidents The seat can come loose from the
anchoring if it is not mounted correctly.
– After assembly, check whether the seat is correctly
locked and cannot be pulled up.
– Finally, check that the passenger seat is correctly mounted.
3.7 Removing the front rider's seat
Preparatory work
– Remove the passenger seat. ( p. 8)
H01993-01
Main work
– Raise the rear of the front rider's seat, pull it towards the rear,
and remove it upwards.

KTM 390 Duke Series 2018 Specifications

General

Displacement	373.2 cc
Bore x Stroke	89 mm x 60 mm
Torque	37 Nm @ 7, 000 rpm
Compression Ratio	12.6:1
Fuel System	Electronic Fuel Injection
Cooling System	Liquid cooled
Transmission	6-speed
Rear Suspension	WP monoshock
Rear Brake	230 mm Disc, Single-Piston Caliper
Front Tire	110/70 ZR17
Rear Tire	150/60 ZR17
Wheelbase	1, 357 mm
Seat Height	830 mm
Ground Clearance	185 mm
Fuel Capacity	13.4 liters
Dry Weight	149 kg
Starter	Electric
Engine Type	Single Cylinder, 4 Stroke, DOHC
Front Suspension	WP upside-down fork, 43 mm
ABS	Yes
Frame	Steel trellis