KTM 390 Duke Series 2018 User Manual

WORK 3
11
V01273-11
–
Position negative cable
4
; mount and tighten the screw.
Finishing work
– Mount the front rider's seat. ( p. 9)
– Mount the passenger seat. ( p. 8)
– Set the time and date. ( p. 11)
3.11 Setting the time and date
Condition
The motorcycle is stationary.
V01172-01
– Press the SET button when the menu is closed.
– Press the UP or DOWN button until Preferences appears. Press
the SET button to open the menu.
– Press the UP or DOWN button until Clock/Date is marked. Press
the SET button to open the menu.
V01173-01
Setting the clock
– Press the UP or DOWN button until the time is marked.
– Press the SET button.
The hour flashes and is underlined.
– Press the UP or DOWN button until the current hour is set.
– Press the SET button.
The minutes flash and are underlined.
– Press the UP or DOWN button until the current minute is
set.
– Press the SET button.
The time is stored.
V01174-01
Setting the date
– Press the UP or DOWN button until the date is marked.
– Press the SET button.
The day flashes and is underlined.
– Press the UP or DOWN button until the current day is set.
– Press the SET button.
The month flashes and is underlined.
– Press the UP or DOWN button until the current month is
set.
– Press the SET button.

KTM 390 Duke Series 2018 Specifications

General

Displacement	373.2 cc
Bore x Stroke	89 mm x 60 mm
Torque	37 Nm @ 7, 000 rpm
Compression Ratio	12.6:1
Fuel System	Electronic Fuel Injection
Cooling System	Liquid cooled
Transmission	6-speed
Rear Suspension	WP monoshock
Rear Brake	230 mm Disc, Single-Piston Caliper
Front Tire	110/70 ZR17
Rear Tire	150/60 ZR17
Wheelbase	1, 357 mm
Seat Height	830 mm
Ground Clearance	185 mm
Fuel Capacity	13.4 liters
Dry Weight	149 kg
Starter	Electric
Engine Type	Single Cylinder, 4 Stroke, DOHC
Front Suspension	WP upside-down fork, 43 mm
ABS	Yes
Frame	Steel trellis

Summary

MEANS OF REPRESENTATION

SETUP

Unpacking and setting up the vehicle

Detailed steps for unpacking the motorcycle from its transport packaging.

WORK

Checking the clutch lever play

Procedure to verify the free play in the motorcycle's clutch lever.

Adjusting play in the clutch lever

Instructions for adjusting the clutch lever free play to specification.

Checking the play in the throttle cable

Procedure to verify the free travel of the motorcycle's throttle cable.

Adjusting the play in the throttle cable

Instructions for adjusting the throttle cable free travel to specification.

Recharging the battery

Installing the battery

Opening the filler cap

Closing the filler cap

Refueling

Checking the headlight setting

Adjusting the headlight range

TECHNICAL DATA

Chassis tightening torques

Specifications for tightening torques for various chassis mounting screws.