EasyManuals Logo
Home>KTM>Motorcycle>50 SX 2012

KTM 50 SX 2012 User Manual

KTM 50 SX 2012
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
15 TUNING THE ENGINE 64
Info
If the speed rise is too high, reduce the idle speed to a normal level and
repeat the preceding steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle adjusting screw to the end without any change of
engine speed, you have to install a smaller idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.
15.7 Carburetor - adjusting idle speed x (50 SX Mini)
700522-01
Screw in idle air adjusting screw 2 all the way and turn it to the specified basic
position.
Guideline
Idle air adjusting screw
Open 1 turn
Run the engine until warm.
Guideline
Warm-up time 5 min
Danger
Danger of poisoningExhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
Adjust the idle speed with adjusting screw 1.
Guideline
Choke function deactivated The choke lever is pushed down all the way.
( p. 14)
Idle speed 1,400… 1,500 rpm
Turn idle air adjusting screw 2 slowly in a clockwise direction until the idle speed
begins to fall.
Note the position and turn the idle air adjusting screw slowly counterclockwise until
the idle speed falls again.
Adjust to the point between these two positions with the highest idle speed.
Info
If the engine speed rises considerably, reduce the idle speed to a normal
level and repeat the above steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle air adjusting screw to the end without any change of
engine speed, you need to install a smaller idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.

Table of Contents

Other manuals for KTM 50 SX 2012

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM 50 SX 2012 and is the answer not in the manual?

KTM 50 SX 2012 Specifications

General IconGeneral
BrandKTM
Model50 SX 2012
CategoryMotorcycle
LanguageEnglish

Related product manuals