ENGLISH
6
OPERATION INSTRUMENTS
»
Clutch lever
The clutch lever [1] is located on the left side of the handlebar. The adjust-
ing screw [A] is used to change the original position of the clutch lever (see
maintenance work on chassis and engine).
Hand decompression lever
The hand decompression lever [2] is only used in two special cases:
a) When the engine stalled.
It is possible that the starter motor is not able to crank the engine on the
next attempt. This is due to the fact that the automatic decompressor
doesn’t work properly. If this happens, pull the manual decompression lever
and start again. Afterwards normal starting will be possible.
b) When you want to push the motorcycle.
While pushing, pull the hand decompression lever to make it easier to get
the engine going.
Hand brake lever (SXC)
The hand brake lever [3] is mounted on the handlebars on the right and actu-
ates the front wheel brake. The adjusting screw [B] can be used to change
the basic position of the hand brake lever (see "Maintenance").
Hand brake lever (SMC)
The hand brake lever [3] is mounted on the right side of the handlebar. The
basic position of the handbrake lever can be changed in 4 steps (see
Maintenance work).
Indicator lamps
The green control lamp [4] flashes when the indicator is working in
the same rhythm as the flashing indicator.
The blue control lamp [5] lights up when the high beam is on.
The green indicator lamp [6] lights up when the neutral gear
is selected.
1
A
2
B
3
4
5
6
3
To Next Page
Loading...
Need help?
General
