KTM 690 SMC 2008 User Manual

WORK 9
100314-10
– Remove screws.
– Open the filler cap. ( S. 8)
– Take off the rear fairing.
– Close the filler cap. ( S. 8)
3.9Fitting rear fairing
100315-10
– Position the license plate holder and cable harness.
– Open the filler cap. ( S. 8)
– Position the rear fairing and grab handles as shown in the figure. Fit and slightly
tighten the screws of the grab handles.
– Close the filler cap. ( S. 8)
– Fit and tighten the screws on the rear fairing.
Guideline
Remaining screws, chassis M6 10Nm (7.4lbfft)
100314-10
– Mount and tighten screws.
– Tighten the screws of the grab handles.
Guideline
Screw, handrail M8 20Nm
(14.8lbfft)
– Mount the seat. ( S. 6)
3.10Fitting the rear footrest bracket
Info
The operations are the same for the left and right sides.
100316-10
– Position the footrest bracket. Mount and tighten screws.
Guideline
Screw, rear footrest bracket M8x16 25Nm
(18.4lbfft)
3.11Fitting heel protector
Info
The operations are the same for the left and right sides.

KTM 690 SMC 2008 Specifications

General

Brand	KTM
Model	690 SMC 2008
Category	Motorcycle
Language	English