3-3
– Remove the bolt of the rear exhaust bracket
1
.
– Pull exhaust pipe out of the rubber sleeve
2
, take of the exhaust
pipe.
– Loosen the two hose clamps
3
and remove the carburetor.
– Let the fuel of the float chamber run out into an appropriate basin.
–Put the carburetor into a clean cloth and lay it on the air filter box.
– Remove the radiator cap.
– Remove drain bolt
4
at the water pump cover and drain cooling
liquid.
– Loosen hose clamp
5
and disconnect the radiator hose.
– Unscrew the three bolts on the clutch slave cylinders and the bolt 6
on the chainguard.
– Remove the chainguard and tilt the clutch slave cylinder
7 to the
side.
6
1
2
4
3
3
5
7
To Next Page
Loading...
Need help?
General
