6-11
Mounting cylinder head
–Clean cylinder and cylinder head sealing surface, place O-rings in
grooves.
– Mount cylinder head with water nozzle on the exhaust side.
– Oil the collar nuts
1 at threads and contact faces.
– Mount the collar bolts with new copper gaskets and tighten them
crosswise, taking three turns to achieve the total tightening torque of
10 Nm.
– In first stage, only tighten until slight resistance is felt.
Mounting the intake flange and reed valve housing
– Mount a gasket and insert the reed valve housing in the intake port.
–Tighten the intake flange to 6 Nm.
Mounting engine sprocket
– Lubricate O-ring 2 with oil and slide over counter shaft.
– Slide distance bushing
3 in position so that O-ring is in correct
position
A.
– Mount the engine sprocket with the collar facing inwards on the
countershaft and fix with circlip
4.
1
A
2
3
4
To Next Page
Loading...
Need help?
General
