KTM 85 SX 2004 User Manual

Repair manual KTM 85 SX Art No 3.206.008-E
6-10
Mounting the ignition
– Degrease the crankshaft and insert the woodruff key in the
crankshaft.
– Fix the stator
1 with 3 collar bolts M5x16 but do not tighten yet.
– Mount the cable guide in the housing opening.
– Mount the rotor on the crankshaft. Then mount the spring ring with
the hexagon nut.
– Insert the holding tool 546.29.012.000
2
into the two bores and
tighten the hexagon nut with 60 Nm.
Adjusting the ignition
– Set the piston to TDC and hold the adjusting plate 470.29.006.000
against the upper edge of the cylinder.
–Turn the rotor in a counterclockwise direction until the upper edge of
the piston rests against the setting gauge (see drawing).
– Now turn the stator until the two marks
3
coincide.
!
CAUTION
!
B
EFORE CHECKING THE IGNITION THE DIMENSION „X“ MUST BE ADJUSTED
CORRECTLY
.
–Tighten the 3 collar bolts on the stator to 6 Nm.
– Once again check the distance between the edge of the piston and
the upper edge of the cylinder using the adjusting plate. If necessary
readjust the distance by rotating the stator.
– Put on a new gasket, and fix the ignition cover by means of the 3
bolts.
1
3
2

KTM 85 SX 2004 Specifications

General

Brand	KTM
Model	85 SX 2004
Category	Motorcycle
Language	English