3 WORK 6
3.1 Installing the wind shield
F00669-11
–
Position wind shield
1
.
–
Mount and tighten screws
2
.
Guideline
Screw, wind shield M5 3.5 Nm
(2.58 lbf ft)
3.2 Removing the seat
F00651-10
–
Insert the ignition key in the seat lock
1
and turn it clockwise by 45°.
– Raise the rear of the seat, pull the seat back, and lift it off.
– Remove the ignition key.
3.3 Mounting the seat
401677-10
–
Hook the catch
1
of the seat onto the fuel tank and lower the rear while pushing
it forward.
–
Insert the locking pin
2
into the lock housing and push down the rear of the seat
until the locking pin engages with an audible click.
– Finally, check that the seat is correctly mounted.
3.4 Recharging the battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the battery.
– Only charge batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and battery gases get into
the eyes.
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
– Do not dispose of batteries as household waste.
– Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
To Next Page
Loading...
Need help?
General
