KTM Freeride 250 F User Manual

3 SERVICE WORK ON THE CHASSIS
16
F01179-10
–
Drill a hole at marking
A
to the size of the marking.
F01180-10
– Route the turn signal cable harness through the frame from
the front to the rear paying attention to the plugs as you do so.
F01181-10
– Join the turn signal cable harness plug-in connector to the
main wiring harness plug-in connector.
–
Mount EFI control unit
1
on the holder.
Info
The wiring harness runs under the EFI control unit.
– Lock the seat. ( p. 18)
F01182-10
– Route the turn signal cable on the left side on the license
plate holder and feed the turn signal cable through the hole.
– Route the cable of the tail light on the right side on the license
plate holder.

KTM Freeride 250 F Specifications

General

Bore x Stroke	78 mm x 52.3 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Rear Suspension	WP Xplor PDS shock absorber
Seat Height	915 mm
Compression Ratio	12.8:1
ABS	No
Engine Type	Single cylinder, 4-stroke
Displacement	249.91 cc
Front Brake	Disc brake, 260 mm
Fuel Tank Capacity	5.5 liters
Fuel System	Electronic fuel injection (EFI)