KTM Freeride 250 F User Manual

3 SERVICE WORK ON THE CHASSIS
6
F01200-10
–
Position the brake caliper. Mount and tighten screws
4
with
the spacers.
Guideline
Screw, front
brake caliper
M8 25 Nm (18.4 lbf ft)
Loctite
®
243™
–
Connect plug-in connector
5
and mount the cable tie(s).
– Position the brake line, wiring harness, and clamp. Mount and
tighten screws
6
.
3.5 Installing V12 shock absorber
F01209-11
–
Push splash protector
1
to the side and position the shock
absorber. Mount and tighten screw
2
.
Guideline
Screw, top
shock absorber
M12 80 Nm (59 lbf ft)
Loctite
®
2701™
–
Mount and tighten screw
3
.
Guideline
Screw, bottom
shock absorber
M12 80 Nm (59 lbf ft)
Loctite
®
2701™
Info
The heim joint for the shock absorber at the swingarm
is Teflon-coated. It must not be greased with grease,
nor with any other lubricants. Lubricants dissolve the
Teflon coating, thereby drastically reducing the service
life.
–
Mount and tighten screw
4
.
Guideline
Screw, upper
subframe
M10 45 Nm (33.2 lbf ft)
Loctite
®
243™
–
Attach brake line
5
.
3.6 Installing V12 combination instrument
H02569-10
– Position the connector retainer and speedometer on the upper
triple clamp.
–
Mount and tighten screws
1
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
– Route the clutch line with the clutch master cylinder toward
the front between the upper and lower triple clamps.

KTM Freeride 250 F Specifications

General

Brand	KTM
Model	Freeride 250 F
Category	Motorcycle
Language	English