21OPERATING THE TRACTOR
BBrake Pedals (Right and Left)
To avoid personal injury:
A Applying only one rear wheel brake at high
speeds could cause the tractor to swerve or
roll-over.
To avoid personal injury:
A An accident may occur if the tractor is
suddenly braked, such as by heavy towed
loads shifting forward or loss of control.
A The braking characteristics are different
between two and four wheel drive. Be aware of
the difference and use carefully.
A When driving on icy, wet or loose surfaces,
make sure the tractor is correctly ballasted to
avoid skidding and loss of steering control.
Operate at reduced speed.
1. Before operating the tractor on the road or before
applying the parking brake, be sure to interlock the
right and left pedals as illustrated below.
2. Use individual brakes to assist in making sharp turns
at slow speeds (Field Operation Only). Disengage the
brake pedal lock and depress only one brake pedal.
3. Be sure brake pedals have equal adjustment when
using locked together.
BClutch Pedal
To avoid personal injury:
A Sudden release of the clutch may cause the
tractor to lunge in an unexpected manner.
The clutch is disengaged when the clutch pedal is fully
pressed down.
To help prevent premature clutch wear:
A The clutch pedal must be quickly disengaged and
be slowly engaged.
3. Checking the brake pedal.
(1) Brake pedal lock (A) "LOCK"
(B) "RELEASE"
4. Raise the implement.
(See "HYDRAULIC UNIT" section.)
(1) Hydraulic control lever
[Except B2320DTN, B2320HSDN]
Position control lever
[B2320DTN, B2320HSDN]
(A) "UP"
5. Depress the Clutch Pedal.
(1) Clutch pedal
To Next Page
Loading...
Need help?
General
