40 PERIODIC SERVICE
■
Checking
Brake Pedal
1. Inspect the brake pedal for free travel, and smooth
operation.
2. Adjust if incorrect measurement is found:
(See "Adjusting Brake Pedal" in every 100 hours
maintenance.)
■
Checking
Gauges, Meter and Easy
Checker
1. Inspect the instrument panel for broken gauge(s),
meter(s) and Easy Checker™ lamps.
2. Replace if broken.
■
Checking
Head Light, Hazard Light etc.
1. Inspect the lights for broken bulbs and lenses.
2. Replace if broken.
■
Checking
and Cleaning of Electrical
Wiring and Battery Cables
A CAUTION
To avoid personal injury:
• A loosened terminal or connector, or damaged
wire may affect the performance of electrical
components or cause short circuits. Leakage
of electricity could result
in a fire hazard, a
dead · battery or damage to electrical
components. Replace damaged wires or
connections promptly. If a fuse blows soon
after replacement, DO NOT USE A LARGER
THAN RECOMMENDED FUSE OR BYPASS THE
FUSE SYSTEM. Many wiring connections are
protected by waterproof plugs, plug and
unplug these connections carefully and make
sure they are sealed correctly after assembly.
Accumulation of dust, chaff or spilled fuel
deposits around the battery, electrical wiring,
engine or exhaust system are a fire hazard.
CLEAN THESE AREAS BEFORE STARTING
WORK.
To avoid premature electrical malfunctions DO
NOT APPLY high pressure water directly to
battery, wiring, connectors, electrical
components or instrument panel.
Inspect the following Regularly:
1. Check wiring for chafed or cracked insulation.
2. Check wiring harness clamps. Replace if necessary.
3. Check connectors and terminals for looseness,
contamination or overheated (discolored)
connections.
4. Check instrument panel for correct operation of
switches and gauges.
Consult your Kubota Dealer regarding maintenance,
diagnosis and repair.
■
Checking
Seat Belt and ROPS
1. Always check condition of seat belt and ROPS
attaching hardware before operating tractor.
2. Replace if damaged.
EVERY 50 HOURS
■
Checking
Engine Start System
A CAUTION.
To avoid personal injury:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test do not
operate the tractor.
♦
Preparation before testing.
1. Sit on operator's seat.
2. Set the parking brake and stop the engine.
3. Shift the range gear shift lever in "NEUTRAL" position.
4. Shift the PTO clutch lever to "OFF" position.
♦
Test 1: Switch for the range gear shift lever
1. Shift the range gear shift lever to "LOW" or "HIGH"
position.
2. Turn the key to "START" position.
3. The engine must not crank.
4. If it cranks, consult your local KUBOTA Dealer for this
service.
• I
<:i
1
t~
I
I
To Next Page
Need help?
General
