23OPERATING THE ENGINE
BCheck Easy Checker(TM) Lamps
Turn the key to "ON" position and make sure the following
indicators light up or stay off.
C Indicators that light up:
1. When the key is turned "ON", indicators(2)(7) should
come on. If trouble should occur at any location while
the engine is running, the indicator corresponding to
that location comes on.
2. Suppose that the engine coolant temperature is not
high enough yet. Glow plug indicator(4) also comes on
when the key is turned "ON" to preheat the engine and
goes off automatically when preheat is completed.
Illumination time of indicator varies according to the
temperature of coolant.
3. The parking brake indicator(3) comes on while parking
brake is applied and goes off when it is released.
4. Turn on the key, and indicators(5)(6) stay on about 1
seconds.
C Indicators that stay off:
1. If the PTO indicator(1) stays on, disengage (OFF) the
PTO.
2. If the cruise control indicator(11) stays on, place the
cruise control lever in neutral (OFF) position.
A Daily checks with the Easy Checker(TM) only, are not
sufficient. Never fail to conduct daily checks carefully
by referring to Daily Check. (See "DAILY CHECK" in
"PERIODIC SERVICE" section.)
A Some of the Easy Checker(TM) lamps may light up or
start flashing depending on the positions of the levers
and switches on the instrument panel.
BIntelliPanel(TM) Message
If you try to start the engine but the following messages
appear alternately in the display, the engine fails to start.
Follow the appearing instructions and reset the display.
[GST / Manual Transmission Type]
(1) Rear PTO indicator
(2) Engine oil pressure indicator
(3) Parking brake indicator
(4) Glow plug indicator
(5) Warning indicator
[HST / GST Type]
(6) Engine overheat indicator
(7) Electrical charge indicator
(8) High-beam indicator
(9) H-DS High speed range
indicator [HST Type]
(10) H-DS Low speed range
indicator [HST Type]
(11) Cruise control indicator
[HST Type]
(12) Stall guardindicator
[HST Type]
(13) Auto H-DS indicator
[HST Type]
8. Fully depress the clutch pedal.
9. Turn the key to "START" position and
release when the engine starts.
(1) Display
To Next Page
Loading...
Need help?
General
