65HYDRAULIC UNIT
HYDRAULIC UNIT
The tractor has 5 hydraulic control systems as shown
below. Therefore, use the most appropriate system for the
implement you are using.
C 3-Point Hitch Control System
1. Position Control
2. Draft Control (if equipped)
3. Mixed Control (if equipped)
4. Float Control
C Remote Hydraulic Control System
5. Combined Flow Control
A Do not operate until the engine is warmed up. If
operation is attempted when the engine is still cold, the
hydraulic system may be damaged.
A If noises are heard when implement is lifting after the
hydraulic control lever has been activated, the
hydraulic mechanism is not adjusted properly. Unless
corrected, the unit will be damaged. Contact your
KUBOTA Dealer for adjustment.
3-POINT HITCH CONTROL SYSTEM
BPosition Control
This will control the working depth of 3-point implements
regardless of the amount of pull required.
Place the draft control lever in the lowest position and set
the implement working depth with the position control
lever.
BDraft Control (if equipped)
This will control the pull of the 3-point implement. As the
load on the 3-point hitch changes due to various soil
conditions, the draft control system automatically
responds to these changes by either raising or lowering
the implement slightly to maintain a constant pull.
Place the position control lever in the lowest position and
set the implement pull with the draft control lever.
(1) Position control lever
(2) Draft control lever
(A) "UP"
(B) "DOWN"
(C) "FLOAT"
(1) Draft control lever
(2) Position control lever
(A) "SENSITIVE"
(B) "INSENSITIVE"
(C) "FLOAT"
To Next Page
Loading...
Need help?
General
