23OPERATING THE TRACTOR
By combination of using the shift lever and the shift switch,
forward speeds and reverse speeds shown in the table
below are obtained.
BMain Gear Shift Lever
To avoid personal injury:
A Before moving the main gear shift lever
(1 2 3 4), make sure the pilot lamp
is on. If the pilot lamp fails to come on, stop the
tractor completely and start the gear shifting all
over.
A Do not shift between and on a downhill
way. The shifting may fail. Be sure to do the
shifting before going downhill.
1. 8 speeds can be selected by the main gear shift lever.
2. The main gear shift is fully synchronized to shift
without stopping.
6. Selecting the Travel Speed.
(1) Hydraulic - shuttle shift lever
(2) Main gear shift lever
(3) Range gear shift lever
(4) Pilot lamp (LOW)
(5) Pilot lamp (HIGH)
(6) Creep lever (if equipped) (F) "FORWARD"
(N) "NEUTRAL POSITION"
(R) "REVERSE"
"LOW"
"HIGH"
(A) "PUSH"
Without creep
16 forward speeds
16 reverse speeds
With creep
24 forward speeds
24 reverse speeds
To Next Page
Loading...
Need help?
General
